146
Views
System view
Predefined user roles
network-admin
Parameters
instance instance-list: Specifies a space-separated list of up to 10 MSTI items. Each item specifies
an MSTI or a range of MSTIs in the form of instance-id1 [ to instance-id2 ]. The value for instance-id2
must be equal to or greater than the value for instance-id1. The value range for the instance-id
argument is 0 to 4094, and the value 0 represents the CIST.
vlan vlan-id-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a
VLAN or a range of VLANs in the form of vlan-id1 [ to vlan-id2 ]. The value for vlan-id2 must be equal
to or greater than the value for vlan-id1. The value range for the vlan-id argument is 1 to 4094.
priority: Specifies the device priority in the range of 0 to 61440 in increments of 4096 (as in 0, 4096,
8192). You can set up to 16 priority values on the device. The smaller the value, the higher the device
priority.
Usage guidelines
If you do not specify an MSTI or VLAN, this command configures the priority of the device in the
MSTP CIST or in the STP or RSTP spanning tree.
Examples
# In MSTP mode, set the device priority to 4096 in MSTI 1.
<Sysname> system-view
[Sysname] stp instance 1 priority 4096
# In PVST mode, set the device priority to 4096 in VLAN 1.
<Sysname> system-view
[Sysname] stp vlan 1 priority 4096
stp region-configuration
Use stp region-configuration to enter MST region view.
Use undo stp region-configuration to restore the default MST region configurations.
Syntax
stp region-configuration
undo stp region-configuration
Default
The default settings for the MST region are as follows:
• The MST region name of the device is the MAC address of the device.
• All VLANs are mapped to the CIST.
• The MSTP revision level is 0.
Views
System view
Predefined user roles
network-admin
To Next Page
Loading...
Need help?
General