HP FlexNetwork 5130 HI series User Manual

74
MAC Information commands
mac-address information enable (interface view)
Use mac-address information enable to enable MAC Information on an interface.
Use undo mac-address information enable to disable MAC Information on an interface.
Syntax
mac-address information enable { added | deleted }
undo mac-address information enable { added | deleted }
Default
MAC Information is disabled on an interface.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
added: Enables the device to record MAC change information when a new MAC address is learned
on an interface.
deleted: Enables the device to record MAC change information when an existing MAC address is
deleted.
Usage guidelines
Before you enable MAC Information on an interface, enable MAC Information globally.
Examples
# Enable MAC Information on GigabitEthernet 1/0/1 to enable the interface to record MAC change
information when learning a new MAC address.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mac-address information enable added
Related commands
mac-address information enable (system view)
mac-address information enable (system view)
Use mac-address information enable to enable MAC Information globally.
Use undo mac-address information enable to disable MAC Information globally.
Syntax
mac-address information enable
undo mac-address information enable
Default
MAC Information is disabled globally.

HP FlexNetwork 5130 HI series Specifications

General

Model	HP FlexNetwork 5130 HI series
Category	Switch
Switch Type	Managed
Layer	Layer 3
Power over Ethernet (PoE)	Available on some models
Fans	Hot-swappable fans
Management	CLI, Web GUI, SNMP, RMON, HP Intelligent Management Center
Routing Protocol	RIP, OSPF, BGP, IS-IS, Static Routing
Layer 3 Features	VRRP
Security Features	ACLs, IEEE 802.1X, RADIUS, TACACS+, SSH, SSL
Quality of Service (QoS)	DiffServ
Weight	Varies by model
Operating Temperature	0°C to 45°C
VLANs	4094
Operating Humidity	10% to 95% non-condensing

Summary

Ethernet Interface Commands

Common Ethernet Interface Commands

Describes basic configuration and display commands for Ethernet interfaces.

Layer 2 Ethernet Interface Commands

Covers Layer 2 specific configurations like storm control and bridging.

MAC Address Table Commands

Ethernet Link Aggregation Commands

Spanning Tree Commands

VLAN Commands

Basic VLAN Commands

Port-Based VLAN Commands

Details commands for configuring port VLANs, including hybrid and trunk ports.

MAC-Based VLAN Commands

Explains how to configure VLANs based on MAC addresses and triggers.

IP Subnet-Based VLAN Commands

Covers VLAN assignment based on IP subnet or IP address.

Protocol-Based VLAN Commands

Private VLAN Commands

Voice VLAN Commands

LLDP Commands