To Next Page

To Previous Page

178

Default

All access ports belong to VLAN 1.

Views

Layer 2 Ethernet interface view, Layer 2 aggregate interface view

Predefined user roles

network-admin

Parameters

vlan-id: Specifies a VLAN by its ID in the range of 1 to 4094.

Usage guidelines

Before assigning an access port to a VLAN, make sure the VLAN has been created.

• The configuration made in Layer 2 Ethernet interface view applies only to the port.

• The configuration made in Layer 2 aggregate interface view applies to the aggregate interface

and its aggregation member ports.

{ If the system fails to apply the configuration to the aggregate interface, it stops applying the

configuration to aggregation member ports.

{ If the system fails to apply the configuration to an aggregation member port, it skips the port

and moves to the next member port.

Examples

# Assign GigabitEthernet 1/0/1 to VLAN 3.

<Sysname> system-view

[Sysname] vlan 3

[Sysname-vlan3] quit

[Sysname] interface gigabitethernet 1/0/1

[Sysname-GigabitEthernet1/0/1] port access vlan 3

port hybrid pvid

Use port hybrid pvid to configure the PVID of a hybrid port.

Use undo port hybrid pvid to configure the PVID of a hybrid port as 1.

Syntax

port hybrid pvid vlan vlan-id

undo port hybrid pvid

Default

The PVID of a hybrid port is the ID of the VLAN to which the port belongs when its link type is

access.