HP FlexNetwork 5130 HI series User Manual

96
Syntax
link-aggregation global load-sharing mode { destination-ip | destination-mac |
destination-port | ingress-port | source-ip | source-mac | source-port } *
undo link-aggregation global load-sharing mode
Default
The system automatically chooses the global link-aggregation load sharing mode according to the
packet type.
The switch can perform link-aggregation load sharing for only Layer 2 or Layer 3 packets.
• If the incoming packets' Type field is 0x0800 or 0x86DD, the switch load shares these packets
as Layer 3 packets by the combination of the following criteria:
{ Source IP address.
{ Destination IP address.
{ Protocol number.
{ Port number.
• If the incoming packets' Type field is not 0x0800 or 0x86DD, the switch load shares these
packets as Layer 2 packets by the combination of the following criteria:
{ Source MAC address.
{ Destination MAC address.
{ Ethernet frame types.
{ VLAN tag.
{ MOD ID.
{ Port ID.
Views
System view
Predefined user roles
network-admin
Parameters
destination-ip: Load shares traffic based on destination IP addresses.
destination-mac: Load shares traffic based on destination MAC addresses.
destination-port: Load shares traffic based on destination ports.
ingress-port: Load shares traffic based on ingress ports.
source-ip: Load shares traffic based on source IP addresses.
source-mac: Load shares traffic based on source MAC addresses.
source-port: Load shares traffic based on source ports.
Usage guidelines
The load sharing mode that you configure overwrites the previous mode.
If unsupported load sharing mode is configured, an error prompt appears.
In system view, the switch supports the following load sharing mode and combinations:
• Load sharing mode automatically determined based on the packet type.
• Source IP address.
• Destination IP address.
• Source MAC address.

HP FlexNetwork 5130 HI series Specifications

General

Brand	HP
Model	FlexNetwork 5130 HI series
Category	Switch
Language	English