EasyManuals Logo
Home>HP>Switch>GbE2c - Blc Layer 2/3 Fiber SFP Option

HP GbE2c - Blc Layer 2/3 Fiber SFP Option User Manual

HP GbE2c - Blc Layer 2/3 Fiber SFP Option
209 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
Configuring the switch 117
The following table describes the Switch Management Processor Configuration (SNMP) controls:
Table 91 Switch Management Processor Configuration (SNMP) controls
Control Description
SNMP System Name Configures the name for the system. The name can have a maximum of 32
characters.
SNMP Location Configures the name of the system location. The location can have a
maximum of 32 characters.
SNMP Contact Configures the name of the system contact. The contact can have a
maximum of 32 characters.
SNMP Read Community String Configures the SNMP read community string. The read community string
controls SNMP “get” access to the switch. It can have a maximum of 32
characters. The default read community string is public.
SNMP Write Community String Configures the SNMP write community string. The write community string
controls SNMP “set” and “get” access to the switch. It can have a
maximum of 32 characters. The default write community string is private.
SNMP state machine timeout (1-30 minutes) Sets the timeout value for the SNMP state machine.
Send SNMP Auth. Failure Traps? Enables or disables the use of the system authentication trap facility. The
default setting is disabled.
Switch Management Processor Configuration buttons
The following table describes the Switch Management Processor Configuration buttons:
Table 92 Switch Management Processor Configuration buttons
Control Description
Submit Sends this form to the switch. Any configuration changes are placed in the “pending” state
and do not take effect until the toolbar Apply command is given.
Diff Shows any pending configuration changes.
Diff Flash Compares new configuration with the flash configuration.
Revert Removes pending configuration changes between apply commands. Use this command to
restore configuration parameters set since last apply command.
Revert Apply Removes pending configuration changes between save commands. Use this command to
restore configuration parameters set since last save command.

Table of Contents

Other manuals for HP GbE2c - Blc Layer 2/3 Fiber SFP Option

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP GbE2c - Blc Layer 2/3 Fiber SFP Option and is the answer not in the manual?

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General IconGeneral
BrandHP
ModelGbE2c - Blc Layer 2/3 Fiber SFP Option
CategorySwitch
LanguageEnglish

Related product manuals