HP GbE2c - Blc Layer 2/3 Fiber SFP Option User Manual

Configuring the switch 162
IP Static Route Configuration
NOTE: This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
To display the following form, go to the IP Static Routes Configuration form. Select a static route ID number, or
open the Network Routes folder and click Add Network Route.
The following table describes the IP Static Route Configuration controls:
Table 131 IP Static Route Configuration controls
Control Description
Route Table Index (1-128) Sets the numeric identifier for this index.
Destination IP Enter the destination IP address for this route.
Mask Enter the subnet mask for this route.
Gateway Enter the IP address of the gateway associated with this route.
Interface Number (1-256) Assigns an interface number to this route.
Static ARP Configuration
To display the following form, select Layer 3 > ARP (click the underlined text, not the folder).
This form summarizes the current static ARP entries. Select a static ARP ID number to display the IP Static ARP
Configuration form.

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English