HP GbE2c - Blc Layer 2/3 Fiber SFP Option User Manual

Configuring the switch 119
The following table describes User Access Configuration controls:
Table 93 User Access Configuration controls
Control Description
User ID (1-10) Sets a numeric identifier for the user.
Set Class of Service Sets the Class-of-Service to define the user’s authority level.
Set user name (0-8 chars) Defines the user name of maximum eight characters.
Set user password (0-128 chars) Sets the user password of up to 128 characters maximum.
Re-type user password (0-128 chars) Confirms the user password.
User Status Enables or disables the user.
Switch RADIUS Configuration
To display the following form, select System > Radius.
The following table describes Switch Radius Configuration controls:
Table 94 Switch RADIUS Configuration controls
Control Description
Primary Radius IP Address Configures the primary Radius server address.
Secondary Radius IP Address Configures the secondary Radius server address.
Radius port (1500-3000) Configures the number of the UDP port to be configured, between 1500 -
3000. The default is 1645.
Radius timeout (1-10) Configures the amount of time, in seconds, before a Radius server
authentication attempt is considered to have failed. The default is 3 seconds.
Radius retries (1-3) Configures the number of failed authentication requests before switching to a
different Radius server. The default is 3 requests.
Enable/Disable Radius Server Enables or disables the Radius server.

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English