HP GbE2c - Blc Layer 2/3 Fiber SFP Option User Manual

Configuring the switch 184
The following table describes the OSPF Virtual Link Configuration controls:
Table 151 OSPF Virtual Link Configuration controls
Control Descriptions
Virtual Link Identifier (1-3) Assigns a numeric identifier to the virtual link.
Area Number (0-2) Defines the area index used by the virtual link.
Enabled? Enables or disables the OSPF virtual link.
Hello Interval (1-65535 sec) Displays the authentication parameters of a hello packet, which is set to be in an interval
of seconds.
Dead Interval (1-65535 sec) Displays the health parameters of a hello packet, which is set to be in an interval of
seconds. Default is 40 seconds.
Transmit Delay (1-3600 sec) Displays the delay in transit in seconds. Default is one second.
Retransmit Interval (1-3600 sec) Displays the retransmit interval in seconds. Default is five seconds.
Virtual Neighbor Router ID Displays the router ID of the virtual neighbor. Default is 0.0.0.0
Authentication Key Displays the password (up to eight characters) for each virtual link. Default is none.
MD5 Key ID (0-255) Sets MD5 key ID for each virtual link. Default is 0 (none).
OSPF Hosts Configuration
NOTE: This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
To display the following form, select Layer 3 > OSPF Routing Protocol > OSPF Hosts (click the underlined text, not
the folder).

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English