Configuring the switch 188
RIP Interface Configuration
NOTE: This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
To display the following form, go to the RIP Interfaces Configuration form. Select a RIP interface number, or open
the RIP Interfaces folder and click Add RIP Interface.
The following table describes the RIP Interface Configuration controls:
Table 156 RIP Interface Configuration controls
Control Descriptions
IP Interface number (1-255) Assigns a numeric identifier to the RIP interface.
Enable RIP? Enables or disables the RIP interface.
RIP Version Configures the RIP version used by this interface.
The default value is version 1.
Default Route Action When enabled, the switch accepts RIP default routes from other routers, but gives them
lower priority than configured default gateways. When disabled, the switch rejects RIP
default routes. The default value is disabled.
Supply Route Updates? When enabled, the switch supplies routes to other routers. The default value is disabled.
Listen to Route Updates? When enabled, the switch learns routes from other routers. The default value is disabled.
Poisoned Reverse? When enabled, the switch uses split horizon with poisoned reverse. When disabled, the
switch uses only split horizon. The default value is disabled.
Triggered Updates? Enables or disables Triggered Updates. Triggered Updates are used to speed
convergence. When enabled, Triggered Updates force a router to send update messages
immediately, even if it is not yet time for the update message. The default value is
disabled.
To Next Page
Loading...
Need help?
General