HP GbE2c - Blc Layer 2/3 Fiber SFP Option User Manual

Configuring the switch 205
ACL Re-Mark Configuration
To display the following form, go to the ACL Configuration Table form, and select an ACL number, or open the
Access Control Lists folder and click Add ACL.
The following table describes the ACL Re-mark configuration controls:
Table 172 ACL Re-mark Configuration controls
Control Description
Set in profile update method Defines the method used to update 802.1p priority updates, as follows:
• User defined – Sets the 802.1p priority for In-Profile packets based on the configured
value.
• Use TOS precedence – Maps the TOS (Type of Service) priority to 802.1p priority for
In-Profile packets.
• Disabled – Disables 802.1p priority mapping for In-Profile packets.
Set in profile user update
priority (0-7)
Defines 802.1p value. The value is the priority bits information in the packet structure.
Set in profile update DSCP
enable
Enables or disables DSCP updates for In-Profile packets.
Set in profile update DSCP
(0-63)
Sets the DiffServ Code Point (DSCP) of In-Profile packets to the selected value.
Set out of profile update DSCP
enable
Enables or disables DSCP updates for Out-of-Profile packets.
Set out of profile update DSCP
(0-63)
Sets the DiffServ Code Point (DSCP) of Out-of-Profile packets to the selected value.

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English