276
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp cpe connect interface gigabitethernet 2/0/1
cwmp cpe connect retry
Use cwmp cpe connect retry to configure the maximum number of attempts the CPE can make to retry a
failed CWMP connection.
Use undo cwmp cpe connect retry to restore the default.
Syntax
cwmp cpe connect retry times
undo cwmp cpe connect retry
Default
The CPE retries a failed connection until the connection is established with the ACS.
Views
CWMP view
Predefined user roles
network-admin
Parameters
times: Specifies the maximum number of CWMP connection retries. The value range is 0 to 100. To
disable the CPE to retry a CWMP connection, set this argument to 0.
Usage guidelines
The CPE retries connecting to the ACS when its initial connection attempt fails or the CWMP session is
ended before the CPE receives a session closed message from the ACS. The CPE stops its connection
retry attempts until the connection is established or the number of connection retries reaches the upper
limit.
Examples
# Set the maximum number of CWMP connection retries to 5.
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp cpe connect retry 5
cwmp cpe inform interval
Use cwmp cpe inform interval to configure the periodic Inform interval.
Use undo cwmp cpe inform interval to restore the default.
Syntax
cwmp cpe inform interval seconds
undo cwmp cpe inform interval
Default
The periodic Inform interval is 600 seconds.
To Next Page
Loading...
Need help?
General
