67
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] route-option bypass-route
source interface
Use source interface to specify the IP address of the specified interface as the source IP address of probe
packets.
Use undo source interface to restore the default.
Syntax
source interface interface-type interface-number
undo source interface
Default
No source IP address is specified for probe packets. The probe packets take the primary IP address of the
outgoing interface as their source IP address.
Views
ICMP echo operation view, UDP tracert operation view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
If you configure the source interface command with the source ip or source ipv6 command, the most
recent configuration takes effect.
The specified source interface must be up. Otherwise, no probe requests can be sent out.
Examples
# Specify the IP address of interface GigabitEthernet 2/0/1 as the source IP address of ICMP echo
request packets.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source interface gigabitethernet 2/0/1
Related commands
source ip
source ip
Use source ip to configure the source IP address for probe packets.
Use undo source ip to remove the configured source address. The IP address of the interface that sends
a probe packet is the source IP address of the probe packet.
To Next Page
Loading...
Need help?
General
