66
Views
DNS operation view
Predefined user roles
network-admin
Parameters
domain-name: Specifies the domain name to be resolved. It is a dot-separated case-sensitive string of 1
to 255 characters including letters, digits, hyphens (-), and underscores (_) (for example, aabbcc.com).
Each part consists of 1 to 63 characters, and consecutive dots (.) are not allowed.
Examples
# Specify domain1 as the domain name to be resolved.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type dns
[Sysname-nqa-admin-test-dns] resolve-target domain1
route-option bypass-route
Use route-option bypass-route to enable the routing table bypass function to test the connectivity to the
direct destination.
Use undo route-option bypass-route to disable the routing table bypass function.
Syntax
route-option bypass-route
undo route-option bypass-route
Default
The routing table bypass function is disabled.
Views
DLSw/DNS/FTP/HTTP/SNMP/TCP/voice operation view
ICMP/UDP echo operation view
UDP jitter operation view
UDP tracert operation view
Predefined user roles
network-admin
Usage guidelines
When the routing table bypass function is enabled, the following events occur:
• The routing table is not searched. Packets are sent directly to the destination in a directly connected
network.
• The TTL value in the probe packet is set to 1. The TTL set in the ttl command does not take effect.
Examples
# Enable the routing table bypass function.
<Sysname> system-view
To Next Page
Loading...
Need help?
General
