284
Field Descri
tion
ACS username Username for the CPE to authenticate to the ACS.
ACS default URL
Default ACS URL.
The CPE attempts to connect to the default ACS URL if no ACS URL has been
assigned to it through the cwmp acs url command, ACS, or DHCP.
This field displays Null if no default ACS URL has been configured.
ACS default username
Username for the CPE to authenticate to the default ACS URL.
This field displays Null if no username has been configured for authentication to
the default ACS URL.
Periodic inform Status of the periodic Inform feature: Enabled or Disabled.
Inform interval Periodic Inform interval. The default interval is 600 seconds.
Inform time
Date and time at which an Inform message is scheduled to be sent. If you do not
schedule an Inform sending, this field displays None.
Wait timeout
Close-wait timer. This timer is configurable with the cwmp cpe wait timeout
command.
Connection retries
Number of attempts the CPE can make to retry a failed CWMP connection.
This field displays Unlimited if the default setting is used. The CPE retries a failed
session until the session is established with the ACS.
Source IP interface
IP address of the specified CWMP connection interface. This field displays None
if you have not specified a CWMP connection interface.
STUN state
Status of NAT traversal for CWMP: Enabled or Disabled.
For the connection request initiated from the ACS to reach the CPE, you must
enable NAT traversal when a NAT gateway resides between the CPE and the
ACS.
SSL policy name
SSL client policy specified for the CPE to authenticate the ACS for establishing an
HTTPS connection. You must specify an SSL client policy when HTTPS is used.
This field displays Null if you have not specified an SSL client policy.
Related commands
display cwmp status
display cwmp status
Use display cwmp status to display CWMP state information.
Syntax
display cwmp status
Views
Any view
Predefined user roles
network-admin
network-operator
To Next Page
Loading...
Need help?
General
