HP MSR4080 User Manual

435
<Sysname> system-view
[Sysname] info-center loghost 1.1.1.1
info-center loghost source
Use info-center loghost source to specify a source IP address for logs sent to log hosts.
Use undo info-center loghost source to restore the default.
Syntax
info-center loghost source interface-type interface-number
undo info-center loghost source
Default
The source IP address of logs sent to log hosts is the primary IP address of the matching route's egress
interface.
Views
System view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies a source interface. The interface's primary IP address will be
used as the source IP address for logs output to log hosts.
Usage guidelines
The info-center loghost source command takes effect only after the information center is enabled with the
info-center enable command.
Examples
# Specify the source interface as loopback 0 for logs sent to log hosts.
<Sysname> system-view
[Sysname] interface loopback 0
[Sysname-LoopBack0] ip address 2.2.2.2 32
[Sysname-LoopBack0] quit
[Sysname] info-center loghost source loopback 0
info-center security-logfile alarm-threshold
Use info-center security-logfile alarm-threshold to set the alarm threshold for security log file usage.
Use undo info-center security-logfile alarm-threshold to restore the default.
Syntax
info-center security-logfile alarm-threshold usage
undo info-center security-logfile alarm-threshold
Default
The alarm threshold for security log file usage is 80. When the usage of the security log file reaches 80%,
the system outputs a message to inform the administrator.

HP MSR4080 Specifications

General

Brand	HP
Model	MSR4080
Category	Network Router
Language	English