HP MSR4080 User Manual

55
Examples
# Create reaction entry 1 for monitoring the average destination-to-source jitter of UDP jitter packets, and
set the upper limit to 50 milliseconds and the lower limit to 5 milliseconds. Before the NQA operation
starts, the initial state of the reaction entry is invalid. After the operation, the average
destination-to-source jitter is checked against the threshold range. If it exceeds the upper limit, the state
of the reaction entry is set to over-threshold. If it is below the lower limit, the state is set to below-threshold.
Once the state of the reaction entry changes, a trap message is generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Sysname-nqa-admin-test-udp-jitter] reaction 1 checked-element jitter-ds threshold-type
average threshold-value 50 5 action-type trap-only
# Create reaction entry 2 for monitoring the destination-to-source jitter of UDP jitter probe packets, and
set the upper limit to 50 milliseconds, and the lower limit to 5 milliseconds. Before the NQA operation
starts, the initial state of the reaction entry is invalid. After the operation, the destination-to-source jitter is
checked against the threshold range. If the total number of threshold violations reaches or exceeds 100,
the state of the entry is set to over-threshold. Otherwise, the state of the entry is set to below-threshold.
Once the state of the reaction entry changes, a trap message is generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Sysname-nqa-admin-test-udp-jitter] reaction 2 checked-element jitter-ds threshold-type
accumulate 100 threshold-value 50 5 action-type trap-only
reaction checked-element { owd-ds | owd-sd }
Use reaction checked-element { owd-ds | owd-sd } to configure a reaction entry for monitoring the
one-way delay.
Use undo reaction to delete the specified reaction entry.
Syntax
reaction item-number checked-element { owd-ds | owd-sd } threshold-value upper-threshold
lower-threshold
undo reaction item-number
Default
No reaction entry for monitoring the one-way delay is configured.
Views
UDP jitter operation view, voice operation view
Predefined user roles
network-admin
Parameters
item-number: Assigns an ID to the reaction entry, in the range of 1 to 10.
owd-ds: Specifies the destination-to-source delay of each probe packet as the monitored element.
owd-sd: Specifies the source-to-destination delay of each probe packet as the monitored element.

HP MSR4080 Specifications

General

Brand	HP
Model	MSR4080
Category	Network Router
Language	English