46
forever: Performs the operation until you stop it by using the undo nqa schedule command.
recurring: Runs the operation automatically at the start time and for the specified duration.
Usage guidelines
You cannot enter the operation view or operation type view of a scheduled NQA operation.
Specify a lifetime long enough for an operation to complete.
Examples
# Schedule the operation with the administrator name admin and operation tag test to start on 08:08:08
2008/08/08 and last 1000 seconds.
<Sysname> system-view
[Sysname] nqa schedule admin test start-time 08:08:08 2008/08/08 lifetime 1000 recurring
Related commands
• destination ip
• nqa entry
• type
operation (FTP operation view)
Use operation to specify the operation type for the FTP operation.
Use undo operation to restore the default.
Syntax
operation { get | put }
undo operation
Default
The FTP operation type is get.
Views
FTP operation view
Predefined user roles
network-admin
Parameters
get: Gets a file from the FTP server.
put: Transfers a file to the FTP server.
Usage guidelines
When you perform the put operation with the filename command configured, make sure the file exists on
the NQA client.
If you get a file from the FTP server, make sure the file specified in the URL exists on the FTP server. The
NQA client does not save the file obtained from the FTP server.
Use a small file for the FTP operation. A big file might result in transfer failure because of timeout, or might
affect other services for occupying much network bandwidth.
To Next Page
Loading...
Need help?
General
