41
max-failure
Use max-failure to set the maximum number of consecutive probe failures in a UDP tracert operation.
Use undo max-failure to restore the default.
Syntax
max-failure value
undo max-failure
Default
A UDP tracert operation stops and fails when it detects five consecutive probe failures.
Views
UDP tracert operation view
Predefined user roles
network-admin
Parameters
value: Specifies the maximum number in the range of 0 to 255. When this argument is set to 0 or 255,
the UDP tracert operation does not stop when consecutive probe failures occur.
Usage guidelines
When a UDP tracert operation detects the maximum number of consecutive probe failures, the operation
fails and stops probing the path.
Examples
# Set the maximum number of consecutive probe failures to 20 in a UDP tracert operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-tracert
[Sysname-nqa-admin-test-udp-tracert] max-failure 20
mode
Use mode to set the data transmission mode for the FTP operation.
Use undo mode to restore the default.
Syntax
mode { active | passive }
undo mode
Default
The FTP operation uses the data transmission mode active.
Views
FTP operation view
Predefined user roles
network-admin
To Next Page
Loading...
Need help?
General
