307
To bind a Tcl-defined policy to a different Tcl script file:
1. Delete the Tcl policy.
2. Create the Tcl policy again, and then bind it to the new Tcl script file.
You can assign the same policy name to a CLI-defined policy and a Tcl-defined policy. However, you
cannot assign the same name to policies that are the same type.
Examples
# Create a Tcl policy and bind it to a Tcl script file.
<Sysname> system-view
[Sysname] rtm tcl-policy test test.tcl
running-time
Use running-time to configure the runtime of a CLI-defined policy.
Use undo running-time to restore the default.
Syntax
running-time time
undo running-time
Default
The runtime of a CLI-defined policy is 20 seconds.
Views
CLI-defined policy view
Predefined user roles
network-admin
Parameters
time: Specifies the runtime of the CLI-defined policy, in the range of 0 to 31536000 seconds. If you
specify 0, the policy can run forever until it is manually interrupted.
Usage guidelines
Policy runtime limits the amount of time that the monitor policy can run from the time it is triggered. When
the runtime is reached, the system stops executing the policy even if the execution is not finished.
This setting prevents an incorrectly defined policy from running permanently to occupy resources.
Examples
# Set the runtime to 60 seconds for the CLI-defined policy test.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] running-time 60
user-role
Use user-role to assign a user role to a CLI-defined policy.
Use undo user-role to remove a user role from a CLI-defined policy.
To Next Page
Loading...
Need help?
General
