87
display ntp-service sessions
Use display ntp-service sessions to display information about all IPv4 NTP associations.
Syntax
display ntp-service sessions [ verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
verbose: Displays detailed information about all IPv4 NTP associations. If you do not specify this
keyword, the command displays only brief information about the NTP associations.
Usage guidelines
When a device is operating in NTP broadcast or multicast server mode, the display ntp-service sessions
command does not display the IPv4 NTP association information corresponding to the broadcast or
multicast server. However, the associations are counted in the total number of associations.
Examples
# Display brief information about all IPv4 NTP associations.
<Sysname> display ntp-service sessions
source reference stra reach poll now offset delay disper
********************************************************************************
[12345]LOCAL(0) LOCL 0 1 64 - 0.0000 0.0000 7937.9
[5]0.0.0.0 INIT 16 0 64 - 0.0000 0.0000 0.0000
Notes: 1 source(master), 2 source(peer), 3 selected, 4 candidate, 5 configured.
Total sessions: 1
Table 15 Command output
Field Descri
tion
source
• When the reference clock is the local clock, the field displays LOCAL
(number). It indicates that the IP address of the local clock is
127.12 7.1. number, where number represents the NTP process number in the
range of 0 to 3.
• When the reference clock is the clock of another device, the field displays
the IP address of the NTP server. If this field displays 0.0.0.0, the IP address
of the NTP server has not been resolved successfully.
To Next Page
Loading...
Need help?
General
