353
Sampler configuration commands
Commands and descriptions for centralized devices apply to the following routers:
• MSR1002-4/1003-8S.
• MSR2003.
• MSR2004-24/2004-48.
• MSR3012/3024/3044/3064.
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.
display sampler
Use display sampler to display configuration information for a sampler.
Syntax
Centralized devices in standalone mode:
display sampler [ sampler-name ]
Distributed devices in standalone mode/centralized devices in IRF mode:
display sampler [ sampler-name ] [ slot slot-number ]
Distributed devices in IRF mode:
display sampler [ sampler-name ] [ chassis chassis-number slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
sampler-name: Specifies a sampler by its name, a case-insensitive string of 1 to 31 characters. If you do
not specify a sampler, this command displays configuration information for all samplers.
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command displays
sampler configuration information for the active MPU. (Distributed devices in standalone mode.)
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command displays sampler configuration information for the master device. (Centralized
devices in IRF mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The chassis-number
argument represents the member ID of the IRF member device. The slot-number argument represents the
slot number of the card. If you do not specify a card, this command displays sampler configuration
information for the global active MPU. (Distributed devices in IRF mode.)
To Next Page
Loading...
Need help?
General
