383
Default
Counting and exporting of MPLS packets are disabled.
Views
System view
Predefined user roles
network-admin
Parameters
label-positions: Specifies position of the labels to be counted.
label-position1: Specifies the position of the first label in the label stack, in the range of 1 to 6.
label-position2: Specifies the position of the second label in the label stack, in the range of 1 to 6.
label-position3: Specifies the position of the third label in the label stack, in the range of 1 to 6.
no-ip-fields: Specifies not to count IP fields.
Usage guidelines
The ip netstream mpls command enables statistics collection of MPLS packets for both IPv4 and IPv6
NetStream.
If multiple labels are to be counted, the label positions specified cannot be the same and are in
ascending order.
Examples
# Enable NetStream of MPLS packets with top label counted and exported but without IP fields.
<Sysname> system-view
[Sysname] ip netstream mpls no-ip-fields
ip netstream timeout active
Use ip netstream timeout active to set the aging timer for active flows.
Use undo ip netstream timeout active to restore the default.
Syntax
ip netstream timeout active minutes
undo ip netstream timeout active
Default
The aging timer is 30 minutes for active flows.
Views
System view
Predefined user roles
network-admin
Parameters
minutes: Sets the aging timer for active flows, in the range of 1 to 60 minutes.
To Next Page
Loading...
Need help?
General
