HUAWEI NetEngine40E Universal ServiceRouter
Hardware Description
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Table 6-86 describes the buttons and indicators on the 1-Port 100GBase-CFP Line Processing
Unit S panel.
Table 6-86 Description of the buttons and indicators on the 1-Port 100GBase-CFP Line
Processing Unit S panel
It is an OFL button. Before removing a board, press the OFL button.
Hold the button for six seconds till the OFL indicator is on. Then, the
board can be pulled out.
If the indicator is steady on, it indicates that you can remove the
board.
If the indicator blinks once every 2s (0.5 Hz), it indicates that the
system is running normally. Otherwise, it indicates that the board
fails to run normally.
If the indicator is steady on, it indicates that the link is normal. If the
indicator blinks, it indicates that data is being transmitted. If the
indicator is off, it indicates that the link is Down.
Interface Attributes
Table 6-87 lists the interface attributes of the 1-Port 100GBase-CFP Line Processing Unit S.
Table 6-87 Interface attributes of the 1-Port 100GBase-CFP Line Processing Unit S
Optical
interface
attributes
Compliant with the selected CFP optical module. (For the attributes of
CFP modules, see Table 6-88)
Ethernet_II, Ethernet_SAP, and Ethernet_SNAP
Table 6-88 Attributes of 100GBase-CFP optical modules
To Next Page
Loading...
Need help?
General
