Rev. 2.0
Maintenance Guide
11-2
1) Detach the whole operation unit from the machine main unit. (M4 hexagon screws at 4
locations)
2) Detach the switch panel cover. (M3 hexagon screws at 4 locations)
3) Detach the operation board.
4) To detach the switch, pull the switch toward you while keeping the metal fittings on the switch
pushed by fingers from the back of the cover.
5) Reassemble the components in the reverse order of disassembly.
Case
Pull out
Panel
Groove
Stop metal fitting
Edge
Mounting
nut
Turn
Turn
To Next Page
Loading...
Need help?
General
