Rev. 2.0
Maintenance Guide
4-6
4-5. Adjusting the Focus
<Procedure>
1) Mount the camera adjustment jig on the top of the CAL block so that the etching surface is
faced downward.
2) Loosen the SEMS cap bolt with washers c and d (total of 6 locations) that secure the
camera, move the camera up and down, and when lines up to 2 on the etching surface are
clearly visible (see the figure below), secure the camera in position.
When the polarizing filter is adjusted to the scale “0” (dark) position, the lines can be seen
easily.
After the adjustment has been completed, return the polarizing filter to the scale “5” (bright)
position.
「2」まわりの線がはっきり
見えること。
カメラアジャスト治具
E2106998000
（T110）
Calibration block
c SM6020302UZ (×2)
c SL6041692TN
(×4)
The lines around "2"
shall be seen clearly.
Camera
adjustment jig
E2106998000
(T110)
To Next Page
Loading...
Need help?
General
