KTM 400 EXC EU 2011 User Manual

301ENGINE - WORK ON THE INDIVIDUAL PARTS 123
Chackinllha balancar shaft
300352-10
Ramovinllha timin chain sprocket
200156-10
- Press in shaft seal ring. all the way, with the open side facing inward.
,/ The spacers. face outward.
-
Press shaft seal ring ., with the open side facing inward, all the way in toward
spacer
•.
- Mount the special tool on the water pump shaft.
I Mounting sleeve (78029044000) ( .- p. 261)
- Mount water pump shaft •.
• Info
I Be careful not to damage the shaft seal rings.
- Mount spacing washer and water pump impeller
•.
- Mount the drive wheel. Mount lock ring •.
- Mount and tighten nut •.
Guideline
Nut, water pump impeller M6
8Nm
Loctit'" 243
111
(5.9 Ibf ft)
- Check bearing surface of the balancer shaft for pitting corrosion.
•
If there is pitting corrosion:
- Change the balancer shaft.
- Check the remaining
areas of the balancer shaft for damage and wear.
•
If there is damage or wear:
- Change the balancer shaft.
-
Warm up the timing chain sprocket. with a blow-<lryer.
- Detach the
timing chain sprocket.
• Info
I The timing chain sprocket is usually damaged by the disassembly and must
be replaced.
301ENGINE - WORK ON THE INDIVIDUAL PARTS 123
Chackinllha balancar shaft
300352-10
Ramovinllha timin chain sprocket
200156-10
- Press in shaft seal ring. all the way, with the open side facing inward.
,/ The spacers. face outward.
-
Press shaft seal ring ., with the open side facing inward, all the way in toward
spacer
•.
- Mount the special tool on the water pump shaft.
I Mounting sleeve (78029044000) ( .- p. 261)
- Mount water pump shaft •.
• Info
I Be careful not to damage the shaft seal rings.
- Mount spacing washer and water pump impeller
•.
- Mount the drive wheel. Mount lock ring •.
- Mount and tighten nut •.
Guideline
Nut, water pump impeller M6
8Nm
Loctit'" 243
111
(5.9 Ibf ft)
- Check bearing surface of the balancer shaft for pitting corrosion.
•
If there is pitting corrosion:
- Change the balancer shaft.
- Check the remaining
areas of the balancer shaft for damage and wear.
•
If there is damage or wear:
- Change the balancer shaft.
-
Warm up the timing chain sprocket. with a blow-<lryer.
- Detach the
timing chain sprocket.
• Info
I The timing chain sprocket is usually damaged by the disassembly and must
be replaced.

KTM 400 EXC EU 2011 Specifications

General

Brand	KTM
Model	400 EXC EU 2011
Category	Motorcycle
Language	English