31/CARBURETOR
Cbeckin~adjustinllhe
nuat
level
172
- Position the accelerator pump cover. Mount and tighten screws
•.
Guideline
I Other screws, carburetor
12
Nm
(1.5
Ibf
It)
- Position
and
mount the bleeder
hoses.
- Position the
hose
holder. Mount
screws.
and tighten all screws in a crisscross
pattern.
Guideline
I
Other
screws,
carburetor
12
Nm
(1.5
Ibf
It)
- Adjust the position
of
the throttle position sensor. (
..
p.
173)
Condition
The carburetor and float chamber
have
been
removed.
-
Tilt
the carburetor to one side, preventing the pin
of
the float from falling out.
-
Tilt
the carburetor until the float rests against the float needle valve but the float
needle valve is not pushed together.
>
If
the edge of the float
is
not parallel to the sealing
area
of the float housing in
this position:
- Adjust the float level by bending float lever
O.
Cblckin
~
nllh.lhrottll
slidl
Up'lninl
•
Info
I The basic setting
of
the throttle slide is
used
to check the beginning of injection of the accelerator pump and the basic setting
of the throttle position sensor.
Condition
The carburetor
has
been
removed.
Check the throttle slide opening using a wire or a drill shank.
I Throttle slide opening
11
mm
(0.04
in)
>
If
the throttle slide opening does not meet specifications:
- Adjust the throttle slide opening with adjusting screw
G.
31/CARBURETOR
Cbeckin~adjustinllhe
nuat
level
172
- Position the accelerator pump cover. Mount and tighten screws
•.
Guideline
I Other screws, carburetor
12
Nm
(1.5
Ibf
It)
- Position
and
mount the bleeder
hoses.
- Position the
hose
holder. Mount
screws.
and tighten all screws in a crisscross
pattern.
Guideline
I
Other
screws,
carburetor
12
Nm
(1.5
Ibf
It)
- Adjust the position
of
the throttle position sensor. (
..
p.
173)
Condition
The carburetor and float chamber
have
been
removed.
-
Tilt
the carburetor to one side, preventing the pin
of
the float from falling out.
-
Tilt
the carburetor until the float rests against the float needle valve but the float
needle valve is not pushed together.
>
If
the edge of the float
is
not parallel to the sealing
area
of the float housing in
this position:
- Adjust the float level by bending float lever
O.
Cblckin
~
nllh.lhrottll
slidl
Up'lninl
•
Info
I The basic setting
of
the throttle slide is
used
to check the beginning of injection of the accelerator pump and the basic setting
of the throttle position sensor.
Condition
The carburetor
has
been
removed.
Check the throttle slide opening using a wire or a drill shank.
I Throttle slide opening
11
mm
(0.04
in)
>
If
the throttle slide opening does not meet specifications:
- Adjust the throttle slide opening with adjusting screw
G.
To Next Page
Loading...
Need help?
General
