KTM 400 EXC EU 2011 User Manual

381lUBRICATION SYSTEM 185
• If the measured value is less than the specification:
- Check the oil pump for wear. Check all oil holes for free flow.
- Switch off the engine.
Warning
Danaer 01 bums Some vehicle components get very hot when the machine
is driven.
- Wear appropriate protective clothing and safety gloves. In case of burns,
rinse immediately with lukewarm water.
- Remove the special tools.
- Mount and tighten the chain adjuster release screw.
Guideline
Screw, unlocking of timing chain ten- M10x1
sioner
Cblcklnllhl ~r all 11'11
• Info
I The gear oil level should only be checked when the engine is cold.
- Stand the motorcycle upright
on a horizontal surface.
Condition
Engine is cold.
10 Nm (7.4 Ibf It)
- Remove gear oil level check screw e. Stand the motorcycle upright.
- Check the gear oil level.
I A small amount of gear oil should flow out.
•
If no gear oil flows out:
- Add gear oil. (
.- p. 186)
- Mount and tighten the gear oil level check screw.
Guideline
I Screw, gear oil level check 18 Nm (5.9 Ibf It)
Cbanllnll1lllr all cleanlnll!!ar ollsereen
- Orain the gear oil and clean the gear oil screen. ( .- p. 185)
- Fill up with gear oil. ( .- p. 186)
o
30149(}'10
Draininllear oil, cleaninl nar oilsereen
Warning
Danler of scaldinl Engine oil and gear oil get very hot when the motorcycle is ridden.
- Wear appropriate protective clothing and safety gloves. In case
of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
- Oil, grease, filters, fuel, cleaners, brake fluid, etc., should
be disposed of as stipulated in applicable regulations.
• Inlo
I Drain the gear oil only when the engine is warm.
381lUBRICATION SYSTEM 185
• If the measured value is less than the specification:
- Check the oil pump for wear. Check all oil holes for free flow.
- Switch off the engine.
Warning
Danaer 01 bums Some vehicle components get very hot when the machine
is driven.
- Wear appropriate protective clothing and safety gloves. In case of burns,
rinse immediately with lukewarm water.
- Remove the special tools.
- Mount and tighten the chain adjuster release screw.
Guideline
Screw, unlocking of timing chain ten- M10x1
sioner
Cblcklnllhl ~r all 11'11
• Info
I The gear oil level should only be checked when the engine is cold.
- Stand the motorcycle upright
on a horizontal surface.
Condition
Engine is cold.
10 Nm (7.4 Ibf It)
- Remove gear oil level check screw e. Stand the motorcycle upright.
- Check the gear oil level.
I A small amount of gear oil should flow out.
•
If no gear oil flows out:
- Add gear oil. (
.- p. 186)
- Mount and tighten the gear oil level check screw.
Guideline
I Screw, gear oil level check 18 Nm (5.9 Ibf It)
Cbanllnll1lllr all cleanlnll!!ar ollsereen
- Orain the gear oil and clean the gear oil screen. ( .- p. 185)
- Fill up with gear oil. ( .- p. 186)
o
30149(}'10
Draininllear oil, cleaninl nar oilsereen
Warning
Danler of scaldinl Engine oil and gear oil get very hot when the motorcycle is ridden.
- Wear appropriate protective clothing and safety gloves. In case
of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
- Oil, grease, filters, fuel, cleaners, brake fluid, etc., should
be disposed of as stipulated in applicable regulations.
• Inlo
I Drain the gear oil only when the engine is warm.

KTM 400 EXC EU 2011 Specifications

General

Brand	KTM
Model	400 EXC EU 2011
Category	Motorcycle
Language	English