Ol/FORK,
TRIPLE
CLAMP
200742-10
00
I
~
I
201351-10
- Drain the fork oil.
•
Info
I Pull out and push in the piston
rod
several times in order
to
pump out the
cartridge until
it
is
empty.
- Clamp the fork leg with the axle clamp.
- Unscrew and remove the compression damping
fitting
•.
•
Info
I Place a fluid collector beneath it,
as
usually some oil will drain out.
-
Remove
the cartridge.
-
Remove
dust boot
•.
-
Remove
fork protector
ri
ng
•.
•
Info
18
I The fork protector ring does not necessarily need to
be
disassembled for the
further repair.
-
Remove
lock ring
•.
•
Info
I The lock ring
has
a coarsely finished end against which the screwdriver can
be
placed.
-
Warm
up the outer tube in
area.
of the lower sliding bushing.
Guideline
15D
'C (122
'F)
- Jerk the outer tube out
of
the inner tube.
•
Info
I The lower sliding
bushing.
must
be
pulled out
of
its bearing seat when
doing this.
Ol/FORK,
TRIPLE
CLAMP
200742-10
00
I
~
I
201351-10
- Drain the fork oil.
•
Info
I Pull out and push in the piston
rod
several times in order
to
pump out the
cartridge until
it
is
empty.
- Clamp the fork leg with the axle clamp.
- Unscrew and remove the compression damping
fitting
•.
•
Info
I Place a fluid collector beneath it,
as
usually some oil will drain out.
-
Remove
the cartridge.
-
Remove
dust boot
•.
-
Remove
fork protector
ri
ng
•.
•
Info
18
I The fork protector ring does not necessarily need to
be
disassembled for the
further repair.
-
Remove
lock ring
•.
•
Info
I The lock ring
has
a coarsely finished end against which the screwdriver can
be
placed.
-
Warm
up the outer tube in
area.
of the lower sliding bushing.
Guideline
15D
'C (122
'F)
- Jerk the outer tube out
of
the inner tube.
•
Info
I The lower sliding
bushing.
must
be
pulled out
of
its bearing seat when
doing this.
To Next Page
Loading...
Need help?
General
