35/WATER PUMP, COOLING SYSTEM 156
– Correct the coolant level and find out the cause of the loss.
Alternative 1
Coolant ( p. 208)
Alternative 2
Coolant (mixed ready to use) ( p. 208)
– Mount the radiator cap.
22.4Checking the coolant level
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
– Do not remove the radiator cap, radiator hoses or other cooling system components when the engine is hot. Allow the
engine and cooling system to cool down. In case of scalding, rinse immediately with lukewarm water.
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
– Avoid contact between coolant and skin, eyes and clothing. If it gets into your eyes, rinse immediately with water and con-
tact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor immedi-
ately. Change clothes that have come into contact with coolants. Keep coolant out of the reach of children.
Condition
Engine is cold.
100283-10
– Stand the motorcycle on its side stand on a horizontal surface.
– Check the coolant level in the compensating tank .
The coolant level must be within the range shown in the figure.
» If the coolant level does not meet specifications:
– Correct the coolant level.
Alternative 1
Coolant ( p. 208)
Alternative 2
Coolant (mixed ready to use) ( p. 208)
100284-10
– Screw off the radiator cap  and check the coolant level in the radiator.
The radiator must be completely filled.
» If the coolant level does not meet specifications:
– Correct the coolant level and find out the cause of the loss.
Alternative 1
Coolant ( p. 208)
Alternative 2
Coolant (mixed ready to use) ( p. 208)
– Mount the radiator cap.
To Next Page
Loading...
Need help?
General
