41/THROTTLE VALVE BODY 170
EPT control unit
– Select model.
– Select "ECU Diagnostics".
– Highlight "EPT throttle motor drive control LC4" control unit.
– Press "Continue".
– Select "ECU Flashing".
– "Please enter the password:"
– Press "Continue".
– Read the safety instructions and create the necessary preliminary conditions.
– Confirm the instructions by clicking on "OK".
– Press "Select file" and select a new mapping.
Info
"The BLZ file and the exhaust system must match!"
– Press the "ECU flash process" button.
– Read the prompt and confirm with "OK".
The new mapping is loaded.
Info
Start the engine and perform an initialization run.
25.4Requesting the enabling code
Condition
The changed EFI control unit and/or the EPT control unit is connected.
The ignition is on.
The diagnostics tool is connected and running.
Flashing of the EFI control unit and/or the EPT control unit is completed.
400687-60
– Select model.
– Select "ECU Diagnostics".
– Highlight the "Injection management EFI LC4" control unit.
– Press "Continue".
– Select "Coding".
– "Please enter the password:"
– Press "Continue".
– Select "Change VIN - New identity".
– Press "Continue".
– Read the information page on the KTM diagnostics tool and, using "Continue", start
the coding process.
– Overwrite the entry under "Please enter VIN:" with the new chassis number.
Info
For used control units, the chassis number programmed last is displayed.
– Press "Continue".
– Select "Code form".
– Press "Print".
The protocol is being printed out.
– Fill out the protocol and send to "diagnostic@ktm.com".
A response mail containing the enabling code arrives.
To Next Page
Loading...
Need help?
General
