KTM 690 Enduro EU 2010 User Manual

01/FORK, TRIPLE CLAMP 13
800090-10
(690 Enduro R)
– Turn adjusting screws  clockwise until they stop.
Info
The adjusting screws are located at the top end of the fork legs.
Make the same adjustment on both fork legs.
– Turn back counterclockwise by the number of clicks corresponding to the fork
type.
Guideline
Rebound damping
Comfort 20 clicks
Standard 15 clicks
Sport 10 clicks
Full payload 10 clicks
Info
Turn clockwise to increase damping; turn counterclockwise to reduce
damping.
5.3Bleeding the fork legs
– Lean the motorcycle on the side stand.
100248-10
(690 Enduro)
– Remove bleeder screws  briefly.
Any excess pressure escapes from the interior of the fork.
– Mount and tighten bleeder screws.
Info
Carry out this action on both fork legs.
800091-10
(690 Enduro R)
– Remove bleeder screws  briefly.
Any excess pressure escapes from the interior of the fork.
– Mount and tighten bleeder screws.
Info
Carry out this action on both fork legs.
5.4Cleaning the dust boots of the fork legs
– Raise the motorcycle with the lift stand. ( p. 9)
– Loosen the fork protection. ( p. 14)
100293-10
– Push dust boot  of both fork legs downwards.
Info
The dust boots should remove dust and coarse dirt particles from the fork
tubes. Over time, dirt can penetrate behind the dust boots. If this dirt is not
removed, the oil seals behind can start to leak.
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the
brake discs.
– Always keep the brake discs free of oil and grease, and clean them with
brake cleaner when necessary.

KTM 690 Enduro EU 2010 Specifications

General

Brand	KTM
Model	690 Enduro EU 2010
Category	Motorcycle
Language	English