13/BRAKE SYSTEM 93
100257-10
– Remove screws on foot brake cylinder .
– To adjust the basic position of the foot brake lever individually, loosen nut and
turn screw accordingly.
Info
The range of adjustment is limited. The screw must be screwed into the
footrest bracket by at least four turns.
– Position foot brake cylinder so that the foot brake lever has the necessary free
travel. Hold screws in place and tighten the nuts.
Guideline
Nut, foot brake cylinder screw M6 10 Nm (7.4 lbf ft)
– Check the free travel of the foot brake lever. ( p. 92)
– Tighten nut .
15.12Checking rear brake fluid level
Warning
Danger of accidents Failure of the brake system.
– If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding.
Warning
Danger of accidents Reduced braking effect caused by old brake fluid.
– Change the brake fluid of the front and rear brake according to the service schedule.
100258-10
– Stand the vehicle upright.
– Check the brake fluid level in the brake fluid reservoir.
» If the fluid level reaches the MIN marking :
– Add rear brake fluid. ( p. 93)
15.13Adding rear brake fluid
Warning
Danger of accidents Failure of the brake system.
– If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding.
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
– Avoid contact with skin and eyes, and keep out of the reach of children.
– Wear suitable protective clothing and goggles.
– If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Danger of accidents Reduced braking effect caused by old brake fluid.
– Change the brake fluid of the front and rear brake according to the service schedule.
To Next Page
Loading...
Need help?
General
