35/WATER PUMP, COOLING SYSTEM 167
22.1Draining the coolant
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
– Do not remove the radiator cap, radiator hoses or other cooling system components when the engine is hot. Allow the
engine and cooling system to cool down. In case of scalding, rinse immediately with lukewarm water.
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
– Avoid contact between coolant and skin, eyes and clothing. If it gets into your eyes, rinse immediately with water and con-
tact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor immedi-
ately. Change clothes that have come into contact with coolants. Keep coolant out of the reach of children.
– Remove the engine guard. ( p. 39)
600616-10
– Stand the motorcycle upright.
– Place a suitable container under the engine.
– Remove screw . Remove the radiator cap.
– Completely drain the coolant.
– Mount the screw with a new seal ring and tighten it.
Guideline
Plug, drain hole of water pump M10x1 15 Nm
(11.1 lbf ft)
– Install the engine guard. ( p. 39)
22.2Filling the cooling system
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
– Avoid contact between coolant and skin, eyes and clothing. If it gets into your eyes, rinse immediately with water and con-
tact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor immedi-
ately. Change clothes that have come into contact with coolants. Keep coolant out of the reach of children.
600618-10
– Stand the motorcycle on its side stand on a horizontal surface.
– Remove radiator cap .
600619-10
– Refill the coolant.
Alternative 1
Coolant ( p. 242)
Alternative 2
Coolant (mixed ready to use) ( p. 242)
– Fill the radiator completely with coolant. Mount radiator cap .
To Next Page
Loading...
Need help?
General
