STORAGE 200
34.1Storage
Info
If you want to garage the motorcycle for a longer period, take the following actions.
Before storing the motorcycle, check all parts for function and wear. If service, repairs or replacements are necessary, you
should do this during the storage period (less workshop overload). In this way, you can avoid long workshop waiting times at the
start of the new season.
– Make sure the tank is as empty as possible so that you can fill up with fresh fuel when you put the motorcycle back into operation.
– Clean the motorcycle. ( p. 198)
– Change the engine oil and filter, clean the oil screens. ( p. 172)
– Check the antifreeze and coolant level. ( p. 168)
– Check the tire air pressure. ( p. 73)
– Remove the battery. ( p. 81)
– Recharge the battery. ( p. 82)
Guideline
Storage temperature of battery without direct sunshine. 0… 35 °C (32… 95 °F)
– The storage place should be dry and not subject to large temperature differences.
Info
KTM recommends jacking up the motorcycle.
– Raise the motorcycle with the lift stand. ( p. 9)
– Cover the motorcycle with a porous sheet or blanket.
Info
Do not use non-porous materials since they prevent humidity from escaping, thus causing corrosion.
Avoid running the engine for a short time only. Since the engine cannot warm up properly, the water vapor produced during
combustion condenses and causes valves and exhaust system to rust.
34.2Putting into operation after storage
– Remove the motorcycle from the lift stand. ( p. 9)
– Recharge the battery. ( p. 82)
– Install the battery. ( p. 81)
– Set the clock. ( p. 96)
– Refuel.
– Carry out checks before putting into operation.
– Make a test ride.
To Next Page
Loading...
Need help?
General
