KTM 690 Enduro EU 2010 User Manual

07/FUEL TANK, SEAT, TRIM 68
0
0
33
0
0
22
400926-10
– Mount special tool .
Pressure testing tool (61029094000) ( p. 248)
– Mount special tool  with nozzle code 0,60.
Testing hose (61029093000) ( p. 248)
– Insert the hose end in a fuel canister.
Guideline
Minimum fuel canister capacity 10 l (2.6 US gal)
– Switch on the ignition.
– Select model.
– Select "ECU Diagnostics".
– Highlight the "Injection management EFI LC4" control unit.
– Press "Continue".
– Select "Actuator test".
– "Please enter the password:"
– Press "Continue".
– Select "Fuel pump relay function test".
– Press "Continue".
– In the KTM diagnostics tool, read the information page and start the actuator test
with "Continue".
Guideline
Maximum duration of actuator test 3 min
400927-01
– Check the fuel pressure with the filler cap closed.
Fuel pressure
When the fuel pump is active 3.3… 3.7 bar (48… 54 psi)
» If the specification is not reached:
– Open the filler cap. ( p. 66)
– Check the tank air vent system.
400928-01
– Check the fuel pressure with the filler cap open.
Fuel pressure
When the fuel pump is active 3.3… 3.7 bar (48… 54 psi)
» If the specification is not reached:
– Check that the fuel line is clear.
– Change the fuel filter. ( p. 68)
– Replace the fuel pump.
– Stop the "Function test of fuel pump control" actuator test by pressing the "Quit" but-
ton.
– Dismantle the special tools.
– Connect the fuel hose connection.
11.8Changing the fuel filter
Danger
Fire hazard Fuel is highly flammable.
– Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
– Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See the notes on refueling.

KTM 690 Enduro EU 2010 Specifications

General

Brand	KTM
Model	690 Enduro EU 2010
Category	Motorcycle
Language	English