10/REAR WHEEL 77
100250-10
– Loosen nut .
– Loosen nuts .
– Adjust the chain tension by turning adjusting screws on the left and right.
Guideline
Chain tension 5 mm (0.2 in)
Turn the left and right adjusting screws so that the markings on the left
and right chain adjusters are in the same position relative to the reference
marks . The rear wheel is then correctly aligned.
Info
The upper chain section must be taut.
Chain wear is not always even, so you should check this setting at different
chain positions.
– Tighten nuts .
– Make sure that the chain adjusters are installed correctly on adjusting screws .
– Tighten nut .
Guideline
Nut, rear wheel spindle M25x1.5 90 Nm
(66.4 lbf ft)
Info
The wide adjustment range of the chain adjusters (30 mm (1.18 in))
enables different secondary transmissions with the same chain length.
The chain adjusters can be turned through 180°.
13.5Adjusting chain guide
100299-10
– Remove screws and . Take off the chain guide.
Condition
Number of teeth: ≤ 44 teeth
– Insert nut in hole . Position the chain guide.
– Mount and tighten screws and .
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
Condition
Number of teeth: ≥ 45 teeth
– Insert nut in hole . Position the chain guide.
– Mount and tighten screws and .
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
13.6Checking the chain, rear sprocket and engine sprocket
100132-10
– Check the rear sprocket and engine sprocket for wear.
» If the rear sprocket and engine sprocket are worn:
– Replace the rear sprocket or engine sprocket.
Info
The engine sprocket, rear sprocket and chain should always be
replaced together.
To Next Page
Loading...
Need help?
General
