04/SHOCK ABSORBER, SWINGARM 53
8.19Assembling the damper
– Assemble the piston rod. ( p. 52)
201279-11
– Push the spring and sleeve onto the compression damping adjuster. Attach the pis-
ton.
– Mount and tighten the compression damping adjuster .
Guideline
Compression damping adjustment M26x1 30 Nm
(22.1 lbf ft)
201277-11
– Mount and tighten screw .
Guideline
Filling port screw M10x1 14 Nm
(10.3 lbf ft)
201288-10
– Fill the damper cartridge about half full.
Shock absorber oil (SAE 2,5) (50180342S1) ( p. 243)
201278-11
– Grease O-ring of the seal ring retainer.
Lubricant (T158) ( p. 244)
– Mount the piston rod carefully.
201276-10
– Install the seal ring bearer and push it under the ring groove.
– Mount lock ring .
Info
Do not scratch the inner surface.
– Pull out the piston rod so that the seal ring retainer rests against the lock ring.
To Next Page
Loading...
Need help?
General
