07/FUEL TANK, SEAT, TRIM 66
11.1Opening filler cap
100227-10
– Lift the cover of the filler cap and insert the ignition key.
– Turn the ignition key 90° counterclockwise and remove the filler cap.
Info
The filler cap has a tank air vent system.
11.2Closing filler cap
100228-01
– Put the filler cap back on and turn the ignition key 90° clockwise.
– Remove the ignition key and fold down the cover.
11.3Removing the seat
100230-10
– Pull on strap and raise the rear of the seat at the same time.
– Pull back the seat and lift it off.
11.4Mounting the seat
100276-10
(690 Enduro)
– Hook slot of the seat onto screw , press the rear downward and at the
same time push it forward.
– Push locking pin into lock housing and push the back of the seat down
until the locking pin locks in place with an audible click.
– Finally, check that the seat is correctly mounted.
800096-10
(690 Enduro R)
– Hook slot of the seat onto screw , press the rear downward and at the
same time push it forward.
– Push locking pin into lock housing and push the back of the seat down
until the locking pin locks in place with an audible click.
– Finally, check that the seat is correctly mounted.
To Next Page
Loading...
Need help?
General
