01/FORK, TRIPLE CLAMP 25
200632-10
– Check the outer tube for damage.
» If damage is found:
– Replace the outer tube.
200665-10
– Check the surface of the sliding bushings.
» If the bronze-colored layer under sliding layer is visible:
– Replace the sliding bushings.
200666-10
– Check the spring length.
Guideline
Spring length with preload spacer(s) 495 mm (19.49 in)
» If the measured value is greater than the specified value:
– Reduce the strength of the pretensioning bushes.
» If the measured value is less than the specified value:
– Increase the strength of the preload spacers.
5.15Assembling the tap compression
Info
These operations are the same on both fork legs.
200704-11
– Clamp the tap compression in a vise using soft jaws.
– Mount O-ring and seal ring .
– Lubricate the O-ring.
Lubricant (T158) ( p. 244)
200705-10
– Mount shim stack .
Info
Mount with the smaller shims facing downward.
– Mount piston with the O-ring.
Info
The side with the larger inside diameter faces upward.
– Lubricate the O-ring of the piston.
Fork oil (SAE 5) ( p. 243)
To Next Page
Loading...
Need help?
General
