01/FORK, TRIPLE CLAMP 16
201337-10
– Remove screws . Remove the fork protector from above.
5.8Installing the fork legs
201337-11
– Slide on the fork protector from above and position it. Mount and tighten screws .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
201336-11
– Slide the fork legs into the triple clamps on both sides.
Info
The bleeder screws must face forwards.
The topmost milled groove in the fork leg must be flush with the top edge of
the upper triple clamp.
The upper fork projection must be the same on both sides.
– Tighten screws on both sides.
Guideline
Screw, top triple clamp M8 17 Nm
(12.5 lbf ft)
Screw, bottom triple clamp M8 12 Nm (8.9 lbf ft)
201335-11
– Position the wheel speed sensor. Mount and tighten screws .
Guideline
Screw, wheel speed sensor M4 2 Nm
(1.5 lbf ft)
Loctite
®
243™
201334-11
– Position the brake line, wiring harness and clamp.
– Mount and tighten screws .
To Next Page
Loading...
Need help?
General
