01/FORK, TRIPLE CLAMP 20
200735-10
– Remove dust boot .
200656-01
– Remove lock ring .
Info
The lock ring has a beveled end where a screwdriver can be applied.
200716-10
– Heat up the outer tube in area of the lower sliding bushings.
Guideline
50 °C (122 °F)
– Pull the outer tube from the inner tube with a jerk.
Info
The lower sliding bushing must be pulled from its bearing seat.
200658-01
– Remove the upper sliding bushing .
Info
Without using a tool, carefully pull the stack apart by hand.
200659-11
– Take off the lower sliding bushing .
– Take off support ring .
– Take off seal ring .
– Take off lock ring .
– Take off dust boot .
– Unclamp the fork leg.
5.11Disassembling the cartridge
Info
These operations are the same on both fork legs.
– Disassemble the fork legs. ( p. 18)
To Next Page
Loading...
Need help?
General
