Starting the engine for driving / switching it off
4.1 Starting the engine from the driver's cab
Operating Manual GMK6300L 3 112 xxx en 4 - 15
xx.xx.xxxx
4.1.9 Starting the engine
H
This section describes only how to start the engine from the driver's cab.
You can also start the engine from the outrigger control units;
à p. 12 - 23.
Refer to the separate operating manual provided by the engine manufac-
turer for operating the engine. The engine can only be started if:
– The bridging plugs have been inserted in all sockets of the carrier and
superstructure for the hand-held control;
à Hand-held control, p. 9 - 114.
– The lamp (1) has gone out (superstructure ignition off).
• Check that the vehicle parking brake is locked.
If the brake is engaged, the parking brake lever will point downwards.
• Switch the transmission to neutral position N; à p. 5 - 28.
Only in this shift position can the engine be started.
s
To Next Page
Loading...
Need help?
General
