Driving with a rigged truck crane
13.6 Driving in combined operation
13 - 14 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
13.6.4 While driving
•
The speed is limited to 8 km/h (5 mph).
• Only drive slowly, do not change up.
• The turning radius should be as great as possible when driving around
corners!
• Steer the truck crane when it is moving, and avoid sudden changes to the
steering!
Never align the truck crane with the level adjustment system if the ground
is uneven. In this case you must raise the truck crane with the outrigger cyl-
inders, level it and then re-lower it;
à Horizontally aligning the truck crane,
p. 13 - 6.
G
Risk of accidents when the carrier ignition is switched off!
In the crane cab: Do not under any circumstances switch off the carrier igni-
tion. In this way, you prevent the engine for driving from being switched off
and the driver in the driver's cab from losing control of the truck crane.
G
Risk of accidents if the parking brake is released!
In the crane cab: Do not under any circumstances release the parking brake.
If the parking brake is released from the crane cab, it cannot be engaged
from the driver's cab. In this case, driving from the driver's cab is
prohibited.
S
Risk of damage to the steering linkage!
The steering linkage can be damaged if the steering wheel is moved while
the vehicle is stationary.
G
Danger of overturning by switching on the suspension!
The suspension must be deactivated (locked) while the rigged truck crane
is on wheels.
When switching on the suspension, the suspension cylinders would
suddenly be pressed together and damaged, and the truck crane could
overturn.
To Next Page
Loading...
Need help?
General
