Starting/switching off the engine – for crane operation
10.3 Switching off the engine
Operating Manual GMK6300L 3 112 xxx en 10 - 21
xx.xx.xxxx
10.3 Switching off the engine
10.3.1 During normal operation, with the ignition lock/with the
hand-held control
If the hand-held control is not connected:
• Turn the ignition key to position 0 – the engine will stop.
If the hand-held control is connected:
• Press the (1) button once – the engine will switch off.
It is not possible to switch off the engine with the ignition lock
After switching off Observe the notes in the appropriate sections;
à In case of short work breaks, p. 11 - 129,
à In case of work breaks of more than 8 hours, p. 11 - 130.
G
Risk of accidents due to suspended loads!
Never switch off the engine whilst a load is suspended. You must have the
control levers at hand in order to intervene at any time.
Always set down the load before you leave the crane cab.
To Next Page
Loading...
Need help?
General
