Driving modes
6.6 Installing/removing the supporting box
Operating Manual GMK6300L 3 112 xxx en 6 - 85
xx.xx.xxxx
6.6.12 Transporting the supporting box on the separate vehicle
•
Check that the outrigger beams are secured against extension during
transportation with the locking pin;
à p. 12 - 32.
• Move the outrigger pads into operating position; à p. 12 - 39.
• Load the supporting box in such a way that other traffic is not endangered.
• Secure the supporting box and mounting equipment with holding ropes
to prevent them from falling from the transport vehicle, slipping or
damaging other parts.
• Load the transport vehicle in such a way that the weight is evenly
distributed.
• Transport the supporting box only on a separate vehicle of sufficient
lifting capacity;
à Dimensions and weights of removable parts, p. 1 - 10.
Lashing eyelets
• Fasten the supporting box for the transport
to the lashing eyelets (1) with holding ropes.
S
Risk of damage to add-on parts on the supporting box and outrigger pads!
Always secure the supporting box against slipping and overturning.
This will prevent damage.
G
Risk of accidents if used improperly!
For transport, attach the supporting box to the provided lashing eyelets
only and only use lifting gear of sufficient lifting capacity.
To Next Page
Loading...
Need help?
General
