Starting/switching off the engine – for crane operation
10.1 Starting the engine – from the crane cab
10 - 16 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
10.1.11 Setting idling speed
• Start the engine; à p. 10 - 12.
The display (1) in the
Monitoring submenu 8 shows the current engine
speed.
You can increase the idling speed for crane operation.
Release the accelerator in order to be able to view the settings below the
current engine speed.
Increasing/reducing the idling speed
• Press the button (1) up/down until the required engine speed has been
reached. When reducing:
– After approx. 3 seconds, idling speed = standard value.
– Engine off after approx. another 3 seconds.
The engine cannot be restarted until approx. 7 seconds have elapsed.
or
• Press the button up/down once. The idling speed (2) increases/reduces by
one level.
Exceeding the idling speed
You can exceed the idling speed at any time using the accelerator.
Once you release the accelerator the engine speed reduces to the pre-set
idling speed.
To Next Page
Loading...
Need help?
General
