Driving modes
6.5 Installing/removing outrigger beams
Operating Manual GMK6300L 3 112 xxx en 6 - 47
xx.xx.xxxx
6.5 Installing/removing outrigger beams
H
If the truck crane is fitted with a removable supporting box (ROB), you can
only assemble/disassemble the front outrigger beams.
à Installing/removing the supporting box, p. 6 - 65.
To rig the outrigger beams, the outriggers must be fitted with hydraulic
connections (1) which can be separated.
During rigging, each outrigger beam is removed and mounted as a com-
plete “package”, consisting of inner and outer outrigger beams, cylinders
and add-on parts.
You will require the following equipment with a sufficient load bearing
capacity:
– An auxiliary crane,
– Suitable lifting gear and guide ropes,
– A chain hoist,
– A separate vehicle.
Dimensions and weights of the outrigger beams;
à p. 1 - 10.
G
Risk of truck crane overturning if not properly supported!
Loads may only be lifted when the truck crane is supported by all the
outriggers.
For this reason, always use an auxiliary crane to lift the outrigger beams.
To Next Page
Loading...
Need help?
General
