Driving modes
6.4 Main boom, removing/installing
6 - 28 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
6.4.4 Removing/attaching the clamps
The hoses for the hydraulic connection and the cables for the electrical con-
nection are attached in the turntable on two clamps (2).
Removing the clamp
• Loosen the retaining pins from the pins (1).
• Remove the clamp (2).
Attaching the clamp
• Insert the clamp (2) onto the pins (1).
• Secure the clamp using the retaining pins.
G
Danger of hands and arms being crushed!
Make sure that the boom pivot pin is bolted before making or removing or
attaching the clamp.
By this means you avoid a swinging main boom crushing your arms or
hands on the turntable.
To Next Page
Loading...
Need help?
General
