Starting the engine for driving / switching it off
4.1 Starting the engine from the driver's cab
Operating Manual GMK6300L 3 112 xxx en 4 - 19
xx.xx.xxxx
• Check that the lamp (1) goes out.
– If the lamp (1) is lit:
The main menu shows a symbol.
– If the lamp (1) flashes:
The steering angle of the 5th and 6th axle line does not relate correctly to
the 1st to 2nd axle line.
• Steer using the steering wheel – the steering angle is automatically
offset, and the lamp (1) goes out.
• Check that the lamp (1) goes out.
If the lamp (1) is lit, the symbol (2) is shown. The steering system has
failed. You must not under any circumstances drive the truck crane.
Contact Manitowoc Crane Care and arrange for the error to be rectified.
When the symbol (2)
is displayed:
The oil supply for the steering is still being built
up. If the symbol does not go out, contact
Manitowoc Crane Care
When the symbol (3)
is displayed:
Service mode on.
Briefly switch the ignition off and then on
again. If the symbol is still shown, contact
Manitowoc Crane Care.
When the symbol (4)
is displayed:
The 5th and 6th axle lines are brought into the
straight running position, as far as is possible,
and can no longer be steered.
It is possible to steer the 1st to 2nd axle lines.
Arrange for the error to be rectified.
S
Risk of accidents because the truck crane cannot be steered!
Under no circumstances may you drive the truck crane when the red
lamp (1) is lit. The truck crane can no longer be steered safely.
The 5th and 6th axle can steer in an uncontrolled manner, which may lead
to serious accidents, even when driving at reduced speed.
To Next Page
Loading...
Need help?
General
